[. . . ] Lampe incandescente Lampe halogène Lampe halogène TBT à transformateur ferromagnétique ou électronique Protection by electronic device: - If there is an overload and it is above the max. [. . . ] As Leader: The dimmer switch can control: - The lighting points that are directly connected to the open phase terminal, using the ON, OFF + and - keys. , - The lighting points associated with it (the actors) using the ON and OFF keys. As Actor: The remote control dimmer can participate in 16 different scenarios, executing the commands from the other Leaders. Locally: The dimmer switch can control: - The lighting points that are directly connected to the open phase terminal, using the ON, OFF + and - keys. , When the remote control dimmer is used in local control, it is possible to record a default light level. Setting the light level of the ON button (excluding learning procedure) : - Set the level using the + and - buttons - Press the + and ON buttons at the same time, for 5 seconds - The load will extinguish and light up again at the ON level The ON level is now saved. [. . . ] To remove the product from the scenario, go to step 3 Step 3 : Record the scenario (on the LEADER) Clear all the scenarios linked with the command key (on the LEADER) The scenario is cleared Press LEARN Press the command key and hold it down for 10 s 5s Clear all the scenarios linked to this product (on the LEADER) Return the product to factory configuration Press LEARN Press LEARN and hold down for 10 s 5s The indicator lamp goes off The indicator lamp blinks slowly 11 The indicator lamp blinks quickly The indicator lamp flashes [. . . ]